The JAA
ATPL Performance
test bank contains questions pertaining to
032-03-01 Take-off
. The following list contains only a relatively small percentage of the pertinent
questions. Our software, which you are free to download now at no cost, will
generally contain a much more complete set of questions associated with this
test bank. This list is intended only to familiarize you in a general way with
the questions of the
Performance
test bank.
 |
GroundSchool:
Performance
JAA ATPL Theory Test Prep Software
for MS-Windows |
|
|
|
That said, while the following questions are intended
as a general familiarization tool, this list may not be up-to-date nor accurate.
We do not update this website as often as we update our software, which will
contain at any moment all questions that we have for a given test / topic. Therefore,
if you need to actually study for your test, instead of using the list below,
we strongly, strongly encourage you to download our GroundSchool
JAA ATPL
written test prep software. Not only is it more complete and up-to-date, but is also considerably faster and more efficient as a study tool.
| Sample Questions
from the JAA ATPL
Performance
Test Bank |
- When an aircraft takes off with the mass limited by the TODA:
- The take-off distance required increases:
- The effect of a runway contaminated with 0.5 cm of slush on take-off calculations would be to decrease the TOM,...
- The speed V2 of a jet aeroplane must be greater than:
- VR for a jet aircraft must be faster than, the greater of:
- VR cannot be lower than:
- The vertical clearance of obstacles required on the take off flight path is:
- Which of the following statements is correct?
- What will be the effect on an aeroplanes performance if aerodrome pressure altitude is decreased?
- When take off mass is limited by VMBE, an increase in the uphill slope will:
- What is the advantage of balancing V1, even in the event of a climb limited take-off?
- Water equivalent depth is:
- The take-off safety speed V2min for turbo-propeller powered aeroplanes with more than three engines may not be less than:
- Which of the following combinations will most likely cause the greatest increase in the take-off distance?TailwindHeadwindUpslopeDownslopeHigh temperatureLow Temperature
- Clearway may not exceed:
- The length of a clearway may be included in:
- During the flight preparation the climb limited take-off mass (TOM) is found to be much greater than the field length limited TOM using 5° flap. In what way can the performance limited TOM be increased? There are no limiting obstacles.
- If the actual take off weight is higher than that recorded on the load sheet, what would the pilot be surprised by?
- What is TODA?
- Which statement regarding V1 is correct?
- VR must be:
- May anti-skid be considered to determine the take-off and landing data?
- The speed Vmu is (class A):
- During aircraft certification, the value of VMCG is found with nose wheel steering inoperative. This is because:
- Vmu is defined as:
- At the same aircraft mass if a higher V1 was used then...
- Reduced take-off thrust should normally not be used when:
- Which of the following represents the maximum value for V1 assuming max tyre speed and max brake energy speed are not limiting?
- If the aerodrome pressure altitude increases, VR... and Vlof...
- Compared with still air, a tailwind will cause the value of V1 to:
- How is V2 affected if T/O flaps 20° is chosen instead of T/O flaps 10° ?
- (Refer to figure 032_5-1)The distances X, Y, Z and W are defined as:
- How does the slush thickness affect the required V1 reduction?
- Which combination of circumstances or conditions would most likely lead to a tyre speed limited take-off?
- During take off, the time between critical engine failure and V1 (recognition time) is assumed to be approximately:
- Which of the following are to be taken into account for the runway in use for take-off?
- The purpose of the MAT limited TOM is to ensure that in the event of the critical engine failing:
The
list above contains 1/4 or less of the actual number of questions
and may not be up to date! Download the software today to get
access to all available questions. |
For
more information about the JAA ATPL
Performance
test bank, click here.
Copyright,
Content, and Accuracy Notice: . Dauntless Software grants visitors
permission to use the contents of this page for personal use - commercial or
public use, including collecting (or harvesting) of any data or material on
this page is strictly prohibited. This material is presented for informational
purposes only and may be in error. Dauntless Software works hard to maintain
our JAA ATPL question banks. If you see an error on this web page, it
is likely NOT an error that is repeated in our software, as our software (unlike
this web page) is connected to our editorial mechanism whose mission is to quickly
identify and correct errors. If you see what you believe to be an error, please
download and try our software to see if the error is repeated there. If you
believe it is, you can use the issue-reporting mechanisms within the software
to contact our editors about any concern you may have and we will be happy to
look into it promptly.
<
|
